Sherwood RD-5503 Provozní pokyny stáhnout pdf (Strana 12)

Operations

ENGLISH

LISTENING TO A PROGRAM SOURCE

Before operation

• Enter the standby mode.

• The STANDBY indicator lights up.

This means that the receiver is not

disconnected from the AC mains and a

small amount of current is retained to

support the operation readiness.

• To switch the power off, push the POWER

switch again.

• Then the power is cut off and the STANDBY

indicator goes off.

• Each time the POWER ON/STANDBY button on the front

panel is pressed, the receiver is turned on to enter the

operating mode or off to enter the standby mode.

• On the remote control, press the POWER ON button to

enter the operating mode or press the STANDBY button to

enter the standby mode.

• In the standby mode, if the INPUT SELECTOR button is

pressed or the INPUT SELECTOR/MULTI CONTROL

knob is rotated, the receiver is turned on automatically and

the desired input is selected.

• Each time the INPUT SELECTOR/MULTI CONTROL knob

is rotated , the input source changes as follows:

→ TUNER ↔ CD ↔ TAPE ↔ VIDEO 1 ↔ VIDEO 2 ←

(Frequency display)

• Each time the BAND button on the front panel or the

TUNER button on the remote control is pressed, the band

changes as follows:

→ FM ST → FM MONO → AM

1. In the standby mode, turn the power on.

2. Select the desired input source.

■Note : Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup

procedures. (For details, refer to "System Setup" on page 26.)

RD-5405(A)_ENG100217_RD-5503(g) 2010-03-30 오전 10:53 페이지 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 118 119

Žádné komentáře

Sherwood RD-5503 Provozní pokyny Strana 12