Sherwood RX-5502 Provozní pokyny

RX-5502(A) 2007.5.17 9:15 AM 페이지 1

91. POWER SWITCHPush this switch to enter the standby mode.To switch the power off, push again this switch.2. POWER ON BUTTONIn the standby mode, when

10LOADING BATTERIESREMOTE CONTROL OPERATION RANGEUse the remote control unit within a range ofabout 7 meters (23 feet) and angles of up to30 degrees

11LISTENING TO A PROGRAM SOURCEOperations• Each time the ON/STANDBY button on the front panel, the receiver is turned on to enter the operating mode o

124. Operate the selected component for playback. Each time the "INPUT SELECT " buttons are pressed, the input source is changed as foll

13• Each time this button is pressed, the correspondingtone mode is selected and shown for 5 seconds asfollows: BASS  TRBL Note:• When the tone dir

14• "BAL" and the balance level are displayed for 5seconds.• If the balance display disappears, start from thestep 11 again.• The balance le

LISTENING TO RADIO BROADCASTSAuto tuning• Each time this button is pressed, the modechanges as follows: Tuning mode : "PRESET" turns off.Pr

16Manual presetting • You can store up to 30 preferred stations in the memory.• "MEM" is flickering for 5 seconds.1. Tune in the desired sta

17• Then "PRESET" lights up.Tuning to preset stations1. After selecting the tuner as an input source, select the preset mode.2. Select the d

18RECORDINGRecording with TAPE• The volume, tone(bass, treble) and balance settings have no effect on the recording signals.• When you select tuner, C

RX-5502(A) 2007.5.17 9:15 AM 페이지 1

• Each time the "ON/STANDBY" button on the frontpanel is pressed, the ROOM2 mode changes asfollows :R2 > OFF ROOM2 off mode ("R2&

• Each time the "INPUT SELECT " buttons are pressed, the ROOM2 input source is changed as follows : TUNER  CD  AUX  DVD  TAPE  PHON

21Troubleshooting GuidePROBLEM POSSIBLE CAUSE REMEDYIf a fault occurs, run through the table below before taking your receiver for repair.If the fault

22 AMPLIFIER SECTION• Power output, 8Ω, THD 0.7 %, 20 Hz~20 kHz, only a pair of speakers driven ... 2 X 100 W• To

21. Read Instructions - All the safety and operating instructions shouldbe read before the product is operated.2. Retain instructions - The safety and

3: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.IntroductionREAD THIS

4CONTENTSSAFETY INSTRUCTIONS ...

5System Connections• Do not plug the AC input cord into the wall AC outlet until all connections are completed.• Be sure to connect the white RCA pin

6• The AUX jacks may also be connected to an additional component.• The DVD jacks may be connected to AUDIO OUT jacks of video components such as DVD

7• You can connect up to four pairs ofspeakers to this receiver and select thevarious combinations of speakers accordingto your tastes.• The speakers

8Front Panel & Remote ControlsREMOTE CONTROLSFLUORESCENT DISPLAYFRONT PANELRX-5502(A) 2007.5.17 9:15 AM 페이지 8